Model 20 SS Bypass 2-Way Airless Foamer / Sprayer

Model # 969752

The Model 20 SS Bypass 2-Way Airless Foamer/Sprayer is a wash/rinse system for quickly applying two chemicals and rinsing through the same hose. Using a 3 - 6 GPM pressure washer, this stainless steel venturi injection system draws and blends 2 chemical concentrate into the water stream to create an accurately diluted solution. The solution is then projected through the discharge hose and foam wand where it draws in atmospheric air to create wet, clinging foam. Use the spray nozzle to apply non-foaming chemicals and simply open the bypass ball valve to rinse at full volume and pressure.

Key Features
  • Designed for 3 - 6 GPM pressure washers
  • Applies 2 separate chemicals or 2 different concentrations of the same chemical
  • Accurately dilutes chemicals to the required ratios and quickly applies them as a spray or wet, clinging foam
  • Foam maximizes chemical contact time and effectiveness and provides visual assurance of coverage
  • Foam impacts at a lower pressure than spray, allowing a pressure washer to be used on more delicate surfaces
  • Use the fan pattern foam nozzle for fast coverage or zero degree foam nozzle for increased range
  • To rinse at full volume and pressure, simply open the bypass ball valve and replace your original rinse nozzle
  • Industrial-strength stainless steel construction, with chemical resistant wetted components, stands up to tough conditions and constant use - Built to last!
  • Your equipment is protected because no chemical passes through the pump
  • Available for 2.2 - 3.5 GPM pressure washers (#969742)
  • See other Lafferty high pressure applicators in Catalog 3
  • Stainless steel mounting base
  • Machined stainless steel bypass injector body
  • High pressure by-pass ball valve & 2 chemical ball valves
  • 20 color-coded precision metering tips to set dilution ratios
  • Machined stainless steel airless foam wand with fan and zero degree nozzles
  • Fan pattern spray nozzle
  • 1/4" quick-connects plugs on each nozzle to connect to your gun
  • 3/8" quick-connect socket for connecting your hose to the injector
Water Temperature up to 180°F
Pressure Washer 3 - 6 GPM
Discharge Hose 3/8" ID minimum x 50'
Stainless Steel Hose Racks
Large Stainless Steel Hose Rack# 224150
Stainless Steel Jug Racks Available
Safe Flow Lid™ for 1 Gallon Jugs
Lid, Suction Tube, and Strainer# 709101
Pressure Washer Hose & Trigger Gun
HP 3/8" x 50' Hose & Trigger Gun Kit# 807069
Inlet Jumper Hose
Hose, 3/8" x 6', BNM, High Pressure# 195006
Lafferty Equipment Manufacturing, Inc.
5614 Oak Grove Road
North Little Rock, AR 72118
TFN: 1-800-999-2820

Comments and/or questions about this website should be addressed to