Overview
The 394 Blast Fogger is a wet mist sprayer that uses compressed air (13 CFM @ 80 PSI) and venturi action to draw ready-to-use chemical solution from any container and project a strong, wet blast of chemical.
Requirements
Ready-to-Use Chemical Solution |
---|
Compressed Air | up to 13 CFM @ 80 PSI |
Minimum Air Supply Line | 3/8" |
Overview
The 394 Blast Fogger is a wet mist sprayer that uses compressed air (13 CFM @ 80 PSI) and venturi action to draw ready-to-use chemical solution from any container and project a strong, wet blast of chemical.
Safety & Operational Precautions
To Install (refer to diagram on next page)
To Operate
Hand Held 394 1-Way FoggerDelivers a strong blast of chemical | ||
---|---|---|
Compressed Air Flow (CFM) | ||
PLUMES | 60 PSI | 80 PSI |
1-Way | 10.0 | 13.0 |
Chemical Solution Draw Rate (fl-oz/min) | ||
DISTANCE | 60 PSI | 80 PSI |
Hand Held | 32.4 | 32.0 |
Troubleshooting Guide |
---|
Problem | Possible Cause / Solution | |
---|---|---|
Startup | Maintenance | |
A) Fogger will not draw chemical or is sputtering B) Fog is too wet | 1, 2, 3, 4 1, 5 |
6, 7, 8, 9 |
Possible Cause / Solution | |
---|---|
Startup | Maintenance |
|
|
PREVENTIVE MAINTENANCE: When the unit will be out of service for extended periods, place chemical tube(s) in water and flush the chemical out of the unit to help prevent chemical from drying out and causing build-up. Periodically check and clean chemical strainer and replace if missing. |