- Make sure the system is not plugged in to a power source. Open the
control box cover. The box contains one timer with both "Delay & Run" adjustment knobs.
Delay: This mode allows
you to set the length of time you want the unit to to be inactive for before fogging begins. Set the timer by turning the knob to the amount
of delay time that you require. (0-6 Hours)
Run: This mode allows
you to set the length of time you want the fogger to run for after the delay period has expired. Set the timer by turning
the knob to the amount of run time that you require. (0-60 Minutes)
- Close and lock the control box cover.
- Plug the power cord into a 120 VAC power outlet. GFI recommended.
SWITCH SETTINGS (There are two lighted rocker switches on the front of the control box.)
- The switch on the left is labeled "On/Off/Auto Ready". With the switch in the "Off" position there is no power to the unit and there are no lights illuminated. Caution: If the switch is set to the "On" position, the green light is illuminated and the unit will automatically start fogging. This is useful during setup and testing with water. Otherwise this setting should be used with care.
- When the timers have been adjusted to required settings, the switch should be set to "Auto Ready". The red light illuminates and this provides power to the second switch on the right hand side of the control box.
- The switch on the right is labeled "Auto Initiate". When you are ready to initiate the "Delay/Run" sequence, press the top of the switch to "Auto Initiate". The green light on this switch is now illuminated. The fogger is now in Delay mode and will perform according to preset
times.
Note: If power is
interrupted after timers have been set, the system stops all timer
operations and needs to be reset.