Water Temperature | up to 180°F |
Pressure Washer | 2.2 - 3.4 GPM |
Discharge Hose |
3/8" ID minimum Up to 200' length |
Requirements
Water Temperature | up to 180°F |
Pressure Washer | 2.2 - 3.4 GPM |
Discharge Hose |
3/8" ID minimum Up to 200' length |
Overview
Safety & Operational Precautions
To Install (refer to diagram on next page)
Set the chemical dilution ratio by threading one of the color coded metering tips into each chemical check valve. See chemical labels for dilution ratio recommendation or consult your chemical supplier.
To Operate
Metering Tip Selection |
||
---|---|---|
Metering Tip Color |
Dilution Ratio AT GPM |
|
2.5 | 3.0 | |
Brown |
571:1 | 686:1 |
Clear |
364:1 | 436:1 |
Bright Purple |
232:1 | 278:1 |
White |
149:1 | 179:1 |
Pink |
109:1 | 131:1 |
Corn Yellow |
83:1 | 100:1 |
Dark Green |
66:1 | 79:1 |
Orange |
55:1 | 67:1 |
Gray |
53:1 | 64:1 |
Light Green |
46:1 | 55:1 |
Med. Green |
40:1 | 48:1 |
Clear Pink |
34:1 | 41:1 |
Yellow Green |
28:1 | 33:1 |
Burgundy |
27:1 | 32:1 |
Pale Pink |
23:1 | 28:1 |
Light Blue |
21:1 | 25:1 |
Dark Purple |
18:1 | 21:1 |
Navy Blue |
13:1 | 15:1 |
Clear Aqua |
11:1 | 13:1 |
Black |
6:1 | 8:1 |
No Tip Ratio Up To: | 5:1 | 7:1 |
The dilution ratios above are approximate values. Due to chemical viscosity, actual dilution ratios may vary. |
Troubleshooting Guide |
---|
Problem | Possible Cause / Solution | |
---|---|---|
Startup | Maintenance | |
A) Unit will not draw chemical. B) Does not foam properly C) Using too much chemical | 1, 2, 3, 7 1, 4, 5, 7 6 |
8, 9, 10, 11, 12, 13 8, 9, 11, 12 |
Possible Cause / Solution | |
---|---|
Startup | Maintenance |
|
|
PREVENTIVE MAINTENANCE: When the unit will be out of service for extended periods, place chemical tube(s) in water and flush the chemical out of the unit to help prevent chemical from drying out and causing build-up. Periodically check and clean chemical strainer and replace if missing. |