Overview
The 324 1-Way Fogger is a chemical atomizer that uses compressed air (15 CFM @ 80 PSI) and venturi action to draw ready-to-use chemical solution. It will atomize the solution and project it as "wet" fog particles up to 30 feet.
Requirements
Ready-to-Use Chemical Solution |
---|
Compressed Air | up to 15 CFM @ 80 PSI |
Minimum Air Supply Line | 3/8" |
Overview
Safety & Operational Precautions
To Install (refer to diagram on next page)
To Operate
324 1-Way FoggerProjects wet fog/mist up to 30' | ||
---|---|---|
Compressed Air Flow (CFM) | ||
PLUMES | 60 PSI | 80 PSI |
1-Way | 11.3 | 15.0 |
Chemical Solution Draw Rate (fl-oz/min) | ||
DISTANCE | 60 PSI | 80 PSI |
12' Above Chemical | 6.1 | 6.6 |
10' Above Chemical | 8.2 | 8.7 |
Hand Held | 13.9 | 14.9 |
Troubleshooting Guide |
---|
Problem | Possible Cause / Solution | |
---|---|---|
Startup | Maintenance | |
A) Fogger will not draw chemical or is sputtering B) Fog is too wet | 1, 2, 3, 4 1, 5 |
6, 7, 8, 9 |
Possible Cause / Solution | |
---|---|
Startup | Maintenance |
|
|
PREVENTIVE MAINTENANCE: When the unit will be out of service for extended periods, place chemical tube(s) in water and flush the chemical out of the unit to help prevent chemical from drying out and causing build-up. Periodically check and clean chemical strainer and replace if missing. |